Running NetBIOS over DECnet Protocol (90260)
The information in this article applies to:
- Microsoft Windows for Workgroups 3.1
- Microsoft Windows for Workgroups 3.11
This article was previously published under Q90260
The following article contains information on the use of Windows for
Workgroups with third-party products or configurations that have not
been tested and are not supported by Microsoft.
If the steps or procedures described in this article do not function
properly, contact the manufacturer of the third-party product for more
information or use a supported configuration.
SUMMARY
When Windows for Workgroups is configured for DECNet Protocol on Lana
0, and NetBEUI on Lana 1, running NetBIOS applications on Lana 0 may
require that you increase the NETHEAPSIZE= entry [386Enh] section of
the SYSTEM.INI file.
MORE INFORMATION
The default setting is NETHEAPSIZE=20. You may have to increase it to
a value greater than 24. Try incrementing this value by 10 or 20 until
your NetBIOS application behaves correctly.
DECNet is manufactured by a vendor independent of Microsoft; we make
no warranty, implied or otherwise, regarding this product's
performance or reliability.
| Modification Type: | Major | Last Reviewed: | 10/14/2003 |
|---|
| Keywords: | KB90260 |
|---|
|