Printing with Cardfile (73008)


The information in this article applies to:

  • Microsoft Windows 3.0
  • Microsoft Windows 3.0a
  • Microsoft Windows 3.1
  • Microsoft Windows 3.11
This article was previously published under Q73008

SUMMARY

This article contains information about printing with the Cardfile program packaged with Microsoft Windows versions 3.0 and later.

MORE INFORMATION

The Windows Cardfile application has two options for printing: Print and Print All. If the Print option is selected, only the active card (at the front of the stack) prints. The Print All option causes all cards in the active file to print.

The default margins allow four cards to print on 8.5 x 11 inch paper. A maximum of five cards can print on an 8.5 x 11 inch sheet of paper. To do this, set the top and bottom margins to .75 (three-quarter inch) by using the Page Setup command under the File menu. This allows the header and footer to print without overlaying any cards. The header and footer are optional and may be deleted using the same Page Setup option as before.

Cardfile only prints cards in a single column running down the page.

Workaround

  1. Change the filename so that it has a .TXT extension.
  2. Open the .TXT file in Microsoft Word for MS-DOS.
  3. Make the desired formatting changes.
  4. Save the file in Word format with a .DOC extension.
NOTE: After performing steps 1-4, this file can be opened in Word for Windows, too.

REFERENCES

"Microsoft Windows User's Guide." Version 3.0, page 396.
Modification Type:MinorLast Reviewed:7/7/2005
Keywords:KB73008
©2004 Microsoft Corporation. All rights reserved.