ActiveX Inline Data Streaming Functionality Is Disabled After You Install the Q313675 Security Patch (317599)

RESOLUTION

WARNING: If you use Registry Editor incorrectly, you may cause serious problems that may require you to reinstall your operating system. Microsoft cannot guarantee that you can solve problems that result from using Registry Editor incorrectly. Use Registry Editor at your own risk.

To enable Inline Data Streaming after you apply the MS01-058 update:

1. Start Registry Editor (Regedit.exe).
2. Locate and click the following registry key:

   HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Internet Explorer\ActiveX Compatibility

3. Click Add Value on the Edit menu, and then add the following registry value:

   Value name: EnableInlineData
   Data type: REG_DWORD
   Radix: Decimal
   Value data: 1

4. Quit Registry Editor.

To protect your data from being read, disable ActiveX controls for all zones. You must determine if you need to run ActiveX controls in your intranet zone (if you are not sure, disable ActiveX controls). If you explicitly trust Internet or intranet sites, and you want to run ActiveX controls from these sites, add these sites (and these sites only) to the trusted zone.

To disable ActiveX controls in the Internet zone:

1. Click Internet Options on the Tools menu, and then click the Security tab.
2. Click Internet in the Select a Web content zone to specify its security settings section, and then click Custom Level.
3. In the Run ActiveX Scripts and Plugins section, click Disable, and then click OK.

To disable ActiveX controls in the intranet zone:

1. Click Internet Options on the Tools menu, and then click the Security tab.
2. Click Intranet in the Select a Web content zone to specify its security settings section, and then click Custom Level.
3. In the Run ActiveX Scripts and Plugins section, click Disable, and then click OK.

To configure Internet Explorer to allow ActiveX controls to run from trusted Web sites, complete the following procedure.

NOTE: The security settings of the Trusted Sites Web content zone uses the Low security setting by default. This setting allows Web sites in the zone to run ActiveX controls and plug-ins.

1. Click Internet Options on the Tools menu, and then click the Security tab.
2. Click Trusted Sites in the Select a Web content zone to specify its security settings section, and then click Sites.
3. Type the hyperlink address of the Web site that you want to add to the trusted site zone in the Add this Web site to the zone box, and then click Add.
   
   NOTE: If the Require Server Verification (https:) for all sites in this zone check box is selected, you can add only addresses that begin with "https:". Hypertext Transfer Protocol server (HTTPS) is a communications protocol that is designed to transfer encrypted information between computers over the Web. HTTPS is Hypertext Transfer Protocol (HTTP) that uses Secure Sockets Layer (SSL).
4. Repeat the preceding step until all of the Web sites that you want to add have been added, and then click OK twice.

For additional information about how to work around this issue, click the article numbers below to view the articles in the Microsoft Knowledge Base:

<OBJECT ID="myCtrl" WIDTH=50 HEIGHT=50
 CLASSID="CLSID:nnnnnnnn-nnnn-nnnn-nnnn-nnnnnnnnnnnn"
 DATA="DATA:application/x-oleobject;BASE64,j43aWGqdGxCvwEIQECqNpy
           FDNBIIAAAA7QMAAO0DAACAfuHmAgAFADEAAAAQ">
</OBJECT>