How to Create a Home Networking Wizard Setup Disk (276352)


The information in this article applies to:

  • Microsoft Windows Millennium Edition
This article was previously published under Q276352

SUMMARY

This article describes how to create a Home Networking Wizard Setup disk after the wizard has completed the installation and configuration.

MORE INFORMATION

To create a Home Networking Wizard Setup disk, follow these steps:
  1. Start the Home Networking Wizard by using either of the following methods:
    • Double-click My Network Places and click Home Networking Wizard.
    • Click Start, point to Programs, point to Accessories, point to Communications, and then click Home Networking Wizard.
    • Click Start, click Run, type netconn.exe, and then click OK.
  2. Click I want to create a floppy disk to set up Home Networking on other computers.
  3. Click Next.
  4. When the disk has been created, insert this disk in the floppy drive of a computer that is running Windows 95, Windows 98, Windows 98 Second Edition or Windows Millennium Edition (Me), click Start, click Run, and then type a:\setup.exe.

REFERENCES

For additional information, click the article numbers below to view the articles in the Microsoft Knowledge Base:

262148 Contents and Function of the Home Networking Wizard Setup Disk

262227 Description of the Home Networking Wizard in Windows Me

Modification Type:MinorLast Reviewed:1/14/2006
Keywords:kbhowto kbnetwork KB276352
©2004 Microsoft Corporation. All rights reserved.