XL2000: Corners of Double Borders Do Not Meet Around Angled Cell (213896)


The information in this article applies to:

  • Microsoft Excel 2000
This article was previously published under Q213896

SYMPTOMS

In Microsoft Excel, if you apply double borders around a cell with an orientation that is set to a value other than 0 (zero), 90, or -90 degrees, the borders may not meet at the corners of the cell.

WORKAROUND

To work around this problem, do not apply double borders around cells that are angled. If you apply any other kind of border, such as a single or dashed border, the problem does not occur.

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.

MORE INFORMATION

You can angle a cell by setting the cell orientation to a value other than 0, 90, or -90 degrees. To do this, follow these steps:
  1. Select the cell that you want to angle.
  2. On the Format menu, click Cells. Click the Alignment tab.
  3. Under Orientation, type or select the angle you want in the Degrees box. Click OK.
To apply borders around a cell, follow these steps:
  1. Select the cell.
  2. On the Format menu, click Cells. Click the Border tab.
  3. In the Style box, select the border style that you want to use. Then, click a side of the diagram in the Border box to apply a single border, or click one of the buttons under Presets.
  4. When you are done, click OK.
The double border is the border in the lower-right corner of the Style box.
Modification Type:MajorLast Reviewed:9/27/2003
Keywords:kbbug kbpending KB213896
©2003 Microsoft Corporation. All rights reserved.