WD2000: VBA Code to Switch a Document to Two-Page View (212729)


The information in this article applies to:

  • Microsoft Word 2000
This article was previously published under Q212729

SUMMARY

This article describes how to use Microsoft Visual Basic for Applications to switch the active document to a two-page view.

MORE INFORMATION

Microsoft provides programming examples for illustration only, without warranty either expressed or implied. This includes, but is not limited to, the implied warranties of merchantability or fitness for a particular purpose. This article assumes that you are familiar with the programming language that is being demonstrated and with the tools that are used to create and to debug procedures. Microsoft support engineers can help explain the functionality of a particular procedure, but they will not modify these examples to provide added functionality or construct procedures to meet your specific requirements.
You can use the following Microsoft Visual Basic for Applications macro to set the magnification of the document window and to display two pages: 

Sub SeeTwoPages()
   With ActiveWindow.View
      ' Switch to page layout view.
      .Type = wdPageView
      With .Zoom
         ' Set view to two pages wide.
         .PageColumns = 2
         ' Set view to one page high.
         .PageRows = 1
      End With
   End With
End Sub

For more information about how to use the sample code in this article, click the article number below to view the article in the Microsoft Knowledge Base:

212536 OFF2000: How to Run Sample Code from Knowledge Base Articles

REFERENCES

For additional information about getting help with Visual Basic for Applications, click the article number below to view the article in the Microsoft Knowledge Base:

226118 OFF2000: Programming Resources for Visual Basic for Applications

Modification Type:MinorLast Reviewed:10/11/2006
Keywords:kbdtacode kbhowto kbmacroexample kbProgramming KB212729
©2004 Microsoft Corporation. All rights reserved.