XADM: Remove Connectors Before Running Move Server Wizard (196413)
The information in this article applies to:
- Microsoft Exchange Server 5.5
This article was previously published under Q196413 SUMMARY
The Move Server Wizard does not move connectors and gateways for delivering
messages to foreign mail systems. All third-party gateways must be removed
before running the wizard. Also, you must remove all connectors installed
on the server, unless you are moving the last server in a site. When you
are moving the last server in a site, the directory replication connector
and any mail connector that supports the directory replication connector
can still be installed when you run the wizard.
After the move, you will need to reconfigure connectors. If prompted,
reinstall Microsoft Exchange Server 5.5 Service Pack 1 to your server. For
more information on how the wizard handles connectors, see the section
"Connectors and Replication" in the Move Server Wizard Help file
(Mvexsrvr.hlp).
MORE INFORMATION
NOTE: If you are moving a server from a multi-server site that has the
Microsoft Mail Connector installed, remove the connector before installing
it on another server in the original site. This will ensure that the
Adminsch mailbox agent is installed on a server that is not moving.
If you have directory synchronization configured with a foreign mail
system, see "Directory Synchronization Issues" in the Move Server Wizard
Help file for tasks that you must perform before the move.
For more information on connectors and gateways, see the chapter for each
connector or gateway in Microsoft Exchange Server Operations.
| Modification Type: | Minor | Last Reviewed: | 4/28/2005 |
|---|
| Keywords: | kbinfo KB196413 |
|---|
|