Digi SDLC Connection Fails With Event 23, Outage Code=002C (189537)
The information in this article applies to:
- Microsoft SNA Server 3.0
- Microsoft SNA Server 3.0 SP1
- Microsoft SNA Server 3.0 SP2
- Microsoft SNA Server 3.0 SP3
- Microsoft SNA Server 4.0
- Microsoft SNA Server 4.0 SP1
This article was previously published under Q189537 SYMPTOMS
A connection configured to connect to a host with the Digi Sync/570I goes
active, but then fails. The following error is logged in the Application
Event Log:
Event ID: 23
Connection Failure
Connection =<connection>
Link Service =<link service>
Outage Code =002C
Invalid SDLC command received. The SDLC driver has reported that an
invalid SDLC command has been received. Either an SDLC I-frame was
received out of sequence, an unrecognized command was received, or the
SDLC frame exceeded the maximum frame size that the SDLC link service
can support.
CAUSE
The old driver needed modification to protect critical regions of code.
RESOLUTION
This problem can be resolved by installing the latest driver for the Digi
Sync/570I SDLC card. The current driver is version 3.3.0, and it is
available for downloading from Digi's FTP site. The driver fixes problems
with data corruption as well as line outages. Follow the steps below to
download the new driver:
- Go to the following URL on the Digi Web site:
- Download the following file:
510128D.exe is a self extracting zip of the installation disk.
Modification Type: | Major | Last Reviewed: | 6/24/2004 |
---|
Keywords: | KB189537 |
---|
|