INFO: Setup Over NWLink Requires SAP on Site Controller (186189)


The information in this article applies to:

  • Microsoft Message Queue Server (MSMQ) 1.0
This article was previously published under Q186189

SUMMARY

Before you attempt to set up Microsoft Message Queue Server (MSMQ) on a computer that will communicate with its site controller using the NWLink IPX/SPX protocol, you must first install the SAP Agent service on the site controller.

If the SAP agent is not installed, the client appears to have normal connectivity to the installation server and site controller, but Independent Client setup will fail with the error code 0xC00E0013, "No connection with this site's controller(s)." Dependent Client setup will fail with the error code 0xC00E000B, "The Message Queues service is not available."

The errors occur because the remote procedure call (RPC) layer of MSMQ uses SAP to resolve host names to IPX addresses.

REFERENCES

For additional information, please see the Microsoft World Wide Web site at

http://www.microsoft.com/msmq/.

Modification Type:MajorLast Reviewed:9/1/1999
Keywords:kbinfo KB186189
©2002 Microsoft Corporation. All rights reserved.