Paste in Label Edit Mode Shows Name Conflict Message Box (182635)
The information in this article applies to:
- Microsoft COM Transaction Integrator for CICS and IMS 1.0
- Microsoft SNA Server 4.0
This article was previously published under Q182635 SYMPTOMS
In Component Builder (CB), pasting text when editing the name of a
parameter causes an error message. The following message box appears:
Title: Name Conflict.
Text: This parameter could not be added as This_Is_Parameter1 because
another item by that name already exists". Either specify another
name and click 'OK', click 'Skip' to skip the item, or click
'Cancel' to abort this operation.
Note that the name is not changed.
This behavior applies to methods, parameters, recordsets, and recordset
members. This is an example uses a parameter.
To demonstrate the problem, perform the following steps:
- Start CB.
- Create a new interface.
- Insert a method.
- Insert two parameters, Parameter1 and Parameter2.
- Right-click Parameter1 and click Rename.
- Change the name to This_Is_Parameter1.
- Click and drag the pointer to highlight only the first part of the name
(This_Is_) you changed in the preceding step. Press CTRL+C to copy it to
the Clipboard.
- Right-click Parameter2 and click Rename.
- Press the HOME key to cancel selection of the entire name and position
the cursor at beginning of the name.
- Press CTRL+V to paste from the Clipboard and the message box appears.
WORKAROUND
To avoid the unwanted error message, you can change the name without using
a paste operation.
STATUS
Microsoft has confirmed this to be a problem in Microsoft COM Transaction
Integrator for CICS and IMS version 1.0. This problem was corrected in
the latest SNA Server version 4.0 U.S. Service Pack. For information on
obtaining this Service Pack, query on the following word in the Microsoft
Knowledge Base (without the spaces):
| Modification Type: | Minor | Last Reviewed: | 3/23/2004 |
|---|
| Keywords: | kbbug kbfix KB182635 |
|---|
|