FIX: In-line Comments Parsed by Microsoft Oracle Driver (180839)

The information in this article applies to:

Microsoft ODBC for Oracle version 2.0 Build 2.73.7269
Microsoft ODBC for Oracle version 2.0 Build 2.73.7283.01
Microsoft ODBC for Oracle version 2.0 Build 2.73.7283.03
Microsoft ODBC for Oracle version 2.0 Build 2.73.7356
Microsoft Data Access Components 2.5

This article was previously published under Q180839

SYMPTOMS

When using in-line comments the Microsoft ODBC for Oracle driver may fail with the following error message:

"Syntax Error or Access Violation".

CAUSE

The driver is incorrectly parsing in-line comments. So far, the word "IS" is the only word that has caused the error to occur.

RESOLUTION

Use the version of the driver that has this problem fixed. See the STATUS section. There is no work around to this problem. You cannot use in-line comments that contain the word "IS" using the currently released version of the driver.

NOTE: Version 1.0 of the Microsoft Oracle driver did not have this problem.

STATUS

Microsoft has confirmed this to be a bug in the Microsoft products listed at the beginning of this article. This problem has been corrected in the Microsoft Oracle ODBC Driver version 2.573.2927 or higher. This driver is available in Visual Studio 6.0, the Data Access Data Access Software Development Kit (SDK) version 2.0 or higher, and Microsoft Data Access Components (MDAC) version 2.0 or higher. You can download the MDAC package from the following Web address:

http://msdn.microsoft.com/dataaccess

MORE INFORMATION

In-line comments can be used to send optimizer hints to the Oracle database engine.

Steps to Reproduce Behavior

Using ODBCTest the problem can be reproduced.

Open a Full Connection.

Enter the following SQL:

      select empno, ename from emp
      where /* This is a comment */ 
      empno = 7369

NOTE: You may need to change the code above to reference a table in your schema.

Execute the code.

The following error message is received:
SQLExecDirect:
In:hstmt = 0x00301250, szSqlStr = "select empno, ename from emp where /* This is a comme...", cbSqlStr = -3 Return: SQL_ERROR=-1 stmt:szSqlState = "42000", *pfNativeError = 0, *pcbErrorMsg = 67, *ColumnNumber = -2, *RowNumber = -2
MessageText = "[Microsoft][ODBC driver for Oracle]Syntax error or access violation"

If you remove the word "IS" in the comment you will not get an error message.

Modification Type:	Major	Last Reviewed:	10/15/2003
Keywords:	kbbug kbDatabase kbDriver kbfix kbOracle KB180839