PRJ98: MS Project Stops Responding with Resource Work Contour (174734)
The information in this article applies to:
- Microsoft Project 98 for Windows
This article was previously published under Q174734 SYMPTOMS
In Microsoft Project 98, when you do any of the following
- Apply a resource view in a project.
- Open a project where a resource view is the active view.
- Save a file in the Microsoft Project Database (*.MPD) format.
you may receive one of the following error messages.
Windows 95
This program has performed an illegal operation and will be shut down. If the Problem persists, contact the program vendor.
If you click Details, you receive an error message similar to the
following:
WINPROJ caused an invalid page fault in module KERNEL32.DLL at <address>.
Windows NT
The instruction at "<address>". The Memory could not be "written".
Click on OK to terminate the application.
CAUSE
This error occurs if the following conditions are true:
- There are more than 320 disjoint (unique) edited values in the
resources' Work field contour.
NOTE: Disjoint means that each of the values in a set of
numbers is unique. For example 1,2,3,4,5 is disjoint but 1,2,3,1,2
is not. - You save, close and then reopen the file, under any of the following
conditions:
- The file is in a resource view when opened (the error will
occur).
- The file is in a task view when opened, and you then apply a
resource view or report.
- You save the file in the MPD format.
WORKAROUND
To work around this problem, do not exceed 320 unique edited resource
contour values.
If you save the file in a resource view with more than 320 unique edits,
you must re-create the file. If you save the file in a task view, you
cannot use a resource view or you will receive the error described in the
"Symptoms" section of this article.
STATUS
Microsoft has confirmed this to be a problem in the versions of Microsoft
Project listed above.
This problem was corrected in Microsoft Project 98 for Windows, Service
Release 1 (SR-1).
For additional information about obtaining and installing SR-1, click the
article number below to view the article in the Microsoft Knowledge Base:
185102
PRJ98: How to Obtain and Install MS Project 98 SR-1
MORE INFORMATION
Modification Type: | Major | Last Reviewed: | 10/17/2002 |
---|
Keywords: | kbbug kberrmsg KB174734 |
---|
|