WD97: Error Message: "Can't Exit Design Mode..." After Adding Control (166784)


The information in this article applies to:

  • Microsoft Word 97 for Windows
This article was previously published under Q166784

SYMPTOMS

When you add a custom control from the Control Toolbox toolbar to your Normal.dot, you may receive the following error message when you create a new document and attempt to access the control:
Can't exit design mode because Control '<Control Type>' can not be created.

CAUSE

The Visual Basic for Applications code for the control must be compiled before you save the Normal.dot template.

RESOLUTION

To resolve this issue:

  • Open your Normal.dot, access the control, and then save and close the Normal.dot template. -or-

  • If you have Visual Basic for Applications code that runs when you access the control, run the procedure prior to saving and closing the Normal.dot template.

STATUS

Microsoft has confirmed this to be a problem in the Microsoft products listed at the beginning of this article.
Modification Type:MajorLast Reviewed:11/14/2000
Keywords:kbbug kberrmsg kbprogramming KB166784
©2002 Microsoft Corporation. All rights reserved.