DIR Command to NetWare Server Using GSNW Results in Error (159728)
The information in this article applies to:
- Microsoft Windows NT Server 4.0
- Microsoft Windows NT Workstation 4.0
This article was previously published under Q159728 SYMPTOMS
When you connect to a NetWare server using the Windows NT Gateway Services
for NetWare (GSNW), if you attempt to use the DIR command in a directory
on the NetWare server, you may receive the following error message:
File not found
If you make a direct connection to the NetWare server (without using
GSNW), this problem does not occur.
CAUSE
This problem occurs when a large number of files exist in the directory
on the NetWare server for which the DIR command is being used.
RESOLUTION
As a workaround, use one of the following methods:
- Connect to the NetWare server directly, without using GSNW.
- Divide the directory on the NetWare server into smaller directories
with fewer files.
| Modification Type: | Major | Last Reviewed: | 8/10/2001 |
|---|
| Keywords: | kbnetwork KB159728 |
|---|
|