No Domain Validation with Intel EtherExpress Pro and IBM Docking Station II (150394)


The information in this article applies to:

  • Microsoft Windows 95
This article was previously published under Q150394

SYMPTOMS

When you use an IBM Docking Station II and an Intel EtherExpress Pro Ethernet network card, computers running Microsoft Windows 95 cannot log on to the network and be validated by a domain controller. Running SoftSet, its diagnostic and setup program, the Loopback test will fail.

CAUSE

The problem is with the amount of electromagnetic interference (EMI) inside the Docking Station II. Under these conditions, the EtherExpress Pro will fail to operate correctly.

RESOLUTION

To work around this problem, change the setting, Force 8 Bit Operation, to True. This slows the card down by making it use 8-bit data transfers instead of 16-bit. This slower transmission rate is sustainable even with the high amounts of EMI. In addition, IBM has released a driver which alters the bus timing and is reported to help ISA cards work in these docking stations.

Microsoft has not tested this driver and makes no claims about its effectiveness.
Modification Type:MajorLast Reviewed:2/20/2002
Keywords:kbinfo KB150394
©2002 Microsoft Corporation. All rights reserved.