Incorrect Error Message Displayed When Dialing Analog Line (147865)
The information in this article applies to:
This article was previously published under Q147865 SYMPTOMS
When you use an ISDN modem with Dial-Up Networking to dial an analog phone
line, you may receive the following error message if there is no answer on
the analog line:
The computer is not receiving a response from the modem. Check that
the modem is plugged in, and if necessary, turn the modem off, and
then turn it back on.
CAUSE
This error message is caused by an incorrect parameter passed from the
NDIS WAN Miniport drivers. When this happens, Dial-Up Networking displays
the generic error message stated above.
STATUS
Microsoft has confirmed this to be a problem in the ISDN Accelerator Pack
for Microsoft Internet Explorer 2.0 version 1.0. We are researching this
problem and will post new information here in the Microsoft Knowledge Base
as it becomes available.
| Modification Type: | Major | Last Reviewed: | 7/28/2001 |
|---|
| Keywords: | kbDialUp KB147865 |
|---|
|