Setting Up Network Client 3.0 On Cogent EM960/964 PCI Adapter (147592)
The information in this article applies to:
- Microsoft Network Client for MS-DOS 3.0
- Microsoft Windows NT Workstation 3.5
- Microsoft Windows NT Workstation 3.51
- Microsoft Windows NT Server 3.5
- Microsoft Windows NT Server 3.51
This article was previously published under Q147592 SYMPTOMS
When you attempt to install the Cogent eMASTER+ EM960 or EM964 10/100 Mbps
PCI network adapter in Network Client 3.0 for MS-DOS, the following error
message appears:
No driver was found in the specified location (path).
RESOLUTION
To correct this problem:
- Run Network Client 3.0 for MS-DOS Setup.
- Select Change Network Configuration and press Enter.
- Select Add Adapter and press Enter.
- Select "*Network adapter not shown on list below..." and press Enter.
- Insert the floppy disk provided by Cogent that contains the network
adapter drivers.
- In Network Client 3.0 for MS-DOS Setup, enter the following:
where <drive> is the drive letter for the floppy disk drive.
- Select the correct Cogent network adapter driver.
The third-party product discussed here is manufactured by Cogent Data
Technologies, a vendor independent of Microsoft; we make no warranty,
implied or otherwise, regarding this product's performance or reliability.
| Modification Type: | Major | Last Reviewed: | 12/16/2003 |
|---|
| Keywords: | KB147592 |
|---|
|