Using RASCOPY.BAT To Install Remote Access Service 1.1a (138810)
The information in this article applies to:
- Microsoft Network Client for MS-DOS 3.0
- Microsoft Remote Access Service 1.1a
This article was previously published under Q138810
The README.TXT file included with the Microsoft Network Client version 3.0
includes instructions describing how to install Remote Access Service (RAS)
1.1a. You are instructed to run the file RASCOPY.BAT after installing the
Network Client software. RASCOPY.BAT will prompt you for RAS 1.1a Disks
1 and 2, even though there is only one setup disk for RAS 1.1a.
When you are prompted for RAS 1.1a Disk 2, simply press enter on the
keyboard to continue without removing RAS 1.1a Disk 1. All files needed
to setup RAS 1.1a are located on Disk 1.
| Modification Type: | Major | Last Reviewed: | 10/14/2003 |
|---|
| Keywords: | KB138810 |
|---|
|